This brown pillow has been on our couch since our student days. But now we’re ready to say goodbye to the old deer. He’s a bit tired and some of his stitching is starting to unravel. I wanted to replace him with something bolder and brighter.
I had picked up some blue shweshwe and yellow piping for another project that I haven’t got around to yet. So I decided to use it to make a new pillow cover. This is a quick project which took about an hour from start to finish.
You will need:
- Sewing machine
Step 1: Wash, air dry and iron your fabric.
Step 2: Take the old pillow case off your pillow and measure each side of the square. My pillow case had lost its shape a bit and each side was a slightly different length. I used the largest side (43cm) to make my square and added on 1.5cm for a seam allowance. Grab some newspaper or a magazine and make a pattern based on your measurements. This will help you cut your square straight. Pin the pattern to your fabric and cut out one square. Step 3: Fold a 1/4 of the template down so that you are left with a rectangle that is 3/4 the length of your pattern. Fold the fabric in half, pin the 3/4 rectangle to the fabric and cut. This will give you the two rectangles which will make up the back of your pillow cover.
Step 4: Take the two rectangles to your ironing board. Fold one of the long sides of your rectangle over by 1cm and iron flat. Fold it over again and iron in place. Repeat with the other rectangle. Using your sewing machine, sew the hems in place on both rectangles. (Don’t worry about the safety of your other fabric. Your cat will guard it for you.)
Step 5: Place your large square right side up on the table. Take your piping and pin it along the edge of the square. The stitching on the piping should be 1.5 cm away from the fabric’s edge. When you get to a corner, take your scissors and make small cuts on the edge of your piping. This will help it lie flat.
Step 6: Head over to your sewing machine. Place the foot of your sewing machine on top of the piping. Position the needle directly over the piping’s existing stitching. Slowly sew on top of the piping’s stitching, removing the pins as you get to them. When you are done you will have a square with piping attached to the outside.
Step 7: Place your square (piping side up) back on the table. Take your first rectangle and place it right side down on top of the square. Match its raw edge with the top raw edge of the square – the hem should reach 3/4 of the way down the square. Take the second rectangle and place it right side down on the square, with its raw edged lined up with the square’s bottom raw edge. It will over lap the other rectangle and will reach 3/4 of the way up the square. Pin the three pieces together.
Step 8: Head back to your sewing machine. Turn the pillow cover over so that the square is facing upwards. You will be able to see the stitching where you attached the piping earlier. Sew directly over that stitching, removing the pins as you go. Turn the pillow inside out and press with an iron. Place the cover back on the pillow and you’re done!
If you enjoyed this post please follow me on Facebook, Twitter and Instagram. You can also sign up for email notifications (at the top of the page).